OVER 250,000 HAPPY CUSTOMERS IN 2019

Desoldering Suction Pump 🔥 HOT SALE NOW 50% OFF! 🔥

Desoldering Suction Pump 🔥 HOT SALE NOW 50% OFF! 🔥
Desoldering Suction Pump 🔥 HOT SALE NOW 50% OFF! 🔥
Desoldering Suction Pump 🔥 HOT SALE NOW 50% OFF! 🔥
Desoldering Suction Pump 🔥 HOT SALE NOW 50% OFF! 🔥
Desoldering Suction Pump 🔥 HOT SALE NOW 50% OFF! 🔥

Desoldering Suction Pump 🔥 HOT SALE NOW 50% OFF! 🔥

Regular price $59.90 Sale price $29.95 USD


Desoldering Suction Pump 🔥 ...

$29.95

Melt and removes the lead with strong suction!

The Desoldering Suction Pump is specially designed to melt and remove the lead with strong suction. It can be used to take the components off the circuit board while not damaging the components and circuit boards. It is specially used for the replacement of integrated circuits and multi-foot switch.

  1. It uses 110v / 220V 50Hz power supply with 30W power
  2. Turn on the power and preheat for 3-5 minutes.
  3. Push down the piston handle. Point the tin suction nozzle at the soldering part. After the lead has melted, press the control button. The leads will be sucked into the cylinder.
  4. The lead suction device is equipped with two different diameter suction nozzles, depending on the thickness of the component lead.
  5. To disassemble the cylinder, press down the top of the cylinder according to the direction of the arrow. Pull the cylinder and the handle apart at the same time, and the cylinder can be separated out. To disassemble the suction nozzle, spin it counterclockwise and remove it.

  1. Check whether the voltage is consistent. Too high or too low voltage is not conducive to use.
  2. Before using, spin the cylinder and the suction nozzle tight to prevent leakage. Otherwise, it will affect the suction.
  3. Clear the solder impurities in the suction nozzle and the cylinder frequently. And add a little oil to the piston.
  4. Every time after using, push the piston 3-4 times to remove the residual straw for the suction nozzle and straw's next smooth use.
  5. Never install the device and remove its electric parts when it's powered on.
  6. It's normal that there is slightly smoke due to heating in the first use of the new suction pump. It will gradually disappear after ten minutes.
  7. When using, a natural cooling soldering iron base must be equipped and the suction pen should be placed in the iron base.
  8. If the power cord is damaged, it must be replaced by the manufacturer to avoid danger.
  9. This product has a ground wire which should be used along with a socket with contacts. 

  • 1 X Desoldering Suction Pump
  • 1 X Nozzle Cleaner
  • 1 X Replaceable Nozzle

OUR GUARANTEE

We truly offer the most stunning and trendy products in the world.

Customer service is our number one priority. If you don't have a positive experience for any reason, we will do whatever it takes to make sure you are 100% satisfied with your purchase.

We have 24/7/365 Email Support. Please contact us at support@allthatstrendy.com if you need assistance.